Nantian Electronics PR9 ES, Service Manual

Page: 55 / 112

PR9 Service Manual
Page 50 of 102
Press key (means move downwards) or key
(means upwards) to check various values .If you want to exit, pressing
key , The LCD shows :
Now you can select other operations you want.
3.3.4.8. RESUME HARDWARE PARAMETER:
This adjustment mainly used to resume the default value of the following
hardware parameters:
Left margin
Top margin
Bi-direction alignment
Once this item was selected, then the correspondent value will be replaced by
the default value and saved into the Flash.
Entering the adjustment, LCD shows:
Press key or key until the
LCD shows:
Press key to accept, LCD shows:
If you want to resume the hardware parameter. Press
key to accept, after
finishing resume, LCD shows:
Now you can select other operations you want.
3.3.5 DEBUG/TEST:
Entering the offline-operation, select the Debug-test, the LCD shows:
Start to select the debug/test
3.3.5.1. CLASSFICATION
3.3.5.1.1. HEX printing: can classified into "Data backup", "Printing backup data"
and "Directly Dump".
3.3.5.1.2. MAGNEITC TEST: can be classified into "READ MAGNEITC" and
"WRITE MAGNEITC".
3.3.5.2. HEX PRINTING