Technical
manual
SMCP33
Commissioning
Issue: V 1.1 - 01.02.2010
7
2 Commissioning
Provisions
Commissioning of the SMCP33 stepper motor is described below.
You will find the main "First Steps" here to start working rapidly with the SMCP33 if
you are using the NanoPro software from a PC.
More detailed information can be found in the separate NanoPro manual.
If you want to work at a later time with a PLC or your own program, you will find the
necessary information in the separate "Programming manual".
Familiarise yourself with the SMCP33 stepper motor control and the corresponding
NanoPro control software before you configure the controller for your application.
Procedure
Proceed as follows to commission the controller:
Step Action
Note
1
Install the NanoPro control software on your PC.
See the separate manual on NanoPro.
Download of
www.nanotec.com
2
Plug the SMCP33 into the motherboard
(SMCP33-EVA evaluation board).
Detailed information on the
SMCP33-EVA can be
found in Section 3.2
SMCP33-EVA evaluation
board and under the
Accessories/Electronics
menu item on
www.nanotec.com
3
Connect the controller to the stepper motor.
Detailed information on
connections can be found
in Chapter 3 „Connections
and circuits“.
4
Switch on the operating voltage
(12 V DC ... 48 V DC).
5
Connect the controller with your PC via the
serial D-Sub 9 or the USB port of the SMCP33-
EVA motherboard.
Use one of the following converter cables for this
purpose:
•
ZK-RS485-RS232 for connection to the serial
interface
•
ZK-RS485-USB for connection to the USB
interface
Order number:
•
ZK-RS485-RS232
•
ZK-RS485-USB
Note:
Download the
necessary driver from
www.nanotec.com under
the Accessories/Converter
menu item