11
2.7.2 Loop Recording
Loop
recording
allows you to set the duration that the camera will record before creating a new clip. To set the clip length
please follow the instructions below.
1.
Press the
OK
Button to stop the Car DVR from recording.
2.
Hold the
M
Button for 2 seconds to enter the
Settings Menu.
3.
Use the
<
and
>
Buttons to navigate the
Settings Menu
and highlight the
Loop Recording
setting and press
OK
to
select.
4.
Use the
<
and
>
Buttons to highlight your required Clip Length, then press the
OK
button to confirm your selection.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.
To avoid filling the card quickly it is advised to use the 2 or 3 minute options.
2.7.3 Motion Detection
Motion
Detection
is used to pause recording when no motion is detected in front of the camera, and to start recording
when motion is detected again. To activate the
Motion Detection
setting follow the instructions below.
1.
Press the
OK
Button to stop the Car DVR from recording.
2.
Hold the
M
Button for 2 seconds to enter the
Settings Menu.
3.
Use the
<
and
>
Buttons to navigate the
Settings Menu
and highlight the
Motion Detection
setting and press
OK
to
select.
4.
Use the
OK
Buttons to turn OFF and ON
Motion Detection
indicated by the check box.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.7.4 Park Mode
When activated,
Park Mode
will monitor the DVR's G Sensor after you have turned off your vehicle. If an impact is detected
the DVR will power up and record a 60 second clip. To set
Park Mode
, follow the instructions below.
1.
Press the
OK
Button to stop the Car DVR from recording.
2.
Hold the
M
Button for 2 seconds to enter the
Settings Menu.
3.
Use the
<
and
>
Buttons to navigate the
Settings Menu
and highlight the
Park Mode
setting and press
OK
to select.
4.
Use the
OK
Buttons to turn OFF and ON
Park Mode
indicated by the check box.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
