16
·
The connection between the light fixture and DMX512 console, light fixture and light fixture should use five core shielded cable and make sure its diameter is not
less than 0.3mm. XLR plug/socket and the wire should be connected as the picture aboved.
·
Pin1, Pin2, Pin3 for connecting DMX singal, Pin4, Pin5 is connectionless.
▲
NOTE: When connect with socket, make sure the internal pin not be in contact with the inner case.The fixture can match the DMX512 (1990) control signal.
·
Plug of five-core and three-core XLR plug/socket conversion.
The fixture comes with five-core XLR plug. lf you use the three-core XLR plug, kindly follow below instruction.
②
DMX-in Port
ln DMX mode, make sure the last light is the only light with cable conected to DMX output. There is a resistance of about 120(OHiM) between the second pin and
third pin of ths plug (as below photo). Make sure this plug is installed into the output interface of the last fixture which can avoid noise and reflection phenomenon
caused by DMX signal in the transmitting process.
③
Set the address of the fixtutre.
④
Refer to the attached DMX channel list and control the light via DMX512 console.
(For specific operation methods, please refer to the DMX512 console operation manual.)
Note: DMX channel list
《
Dyno 650C/Dyno 1200C DMX REFERENCE GUIDE
》
please download it from www.nanlux.com.
Three Pin
Pin 1: GND(SCREEN)
Pin 2: Signal(-)
Pin 3: )
Five Pin
Pin 1: GND(SCREEN)
Pin 2: Signal(-)
Pin 3: )
Pin 4: N/C
Pin 5: N/C
Plug of DMX circuit connection
connect a 120(OHM) resistance
between the 2pin and 3pin of the
XLR plug and then connect it to
the DMX output interfence of
the last fixture.
PIN 2 PIN 3
120Ω
1
3
2
