4
3-Pin DMX circuit connection
Connect a 120(OHM) resistance
between the 2pin and 3pin of the
XLR plug and then connect it to
the DMX output socket of the
last fixture.
120Ω
1
3
PIN 2
PIN 3
2
2
.
3-Pin DMX circuit
In DMX mode, make sure the last light is the only light with cable connected to DMX output. There is a resistance
about 120(OHM) between the second pin and third pin of this plug(as below photo). Make sure this plug is installed
into the output of the last fixture which can avoid noise and reflection phenomenon caused by DMX signal in the
transmitting process.
3
.
DMX channel control
When the light is single color, select the address code to 001, it correspond to the CH1 of the console. After
confirming the address code, the address code will be the last setting address when turning on the light.
Five Pin
Pin 1:GND(SCREEN)
Pin 2:Signal(-)
Pin 3:)
Pin 4:N/C
Pin 5:N/C
Three Pin
Pin 1:GND(SCREEN)
Pin 2:Signal(-)
Pin 3:)