N & W Global Vending – TECHNI CAL MANUAL
This document w as produced by MARK AC for the exclusive use of the technical personnel in the after- sales service.
All rights reserved. No part of this document may be divulged to a third party or reproduced partially or entirely w ithout the prior permission of N & W GLOBAL
VENDI NG
“KORI NTO FB”
23/ 08/ 06
Page 11 / 38
4 – ELECTRI CAL SAFETY AND RELEVANT
STANDARDS
The vending machine
KORI NTO
was designed and made in conformity with the
provisions of the following directives and related European standards:
MACHI NE SAFETY DI RECTI VE EEC 98/ 37
EN 60529 UNI EN 292 –1-2 I EC 695-2-2
LOW VOLTAGE DI RECTI VE EEC 73/ 23; EEC 89/ 392; EEC
89/ 336
(the low voltage directive covers all equipment powered with voltage below 400 V AC)
The following European standards are applied:
EN 60335-2-14 EN 60335-2-15 EN 60335-2-24 EN 60335-2-75
ELECTROMAGNETI C COMPATI BI LI TY DI RECTI VE
EN 61000-3-3 EN 61000-4-2 EN 61000-4-3 EN 61000-4-4 EN 61000-4-5 EN 61000-4-11
---…----…---…---
With regard to
Low Voltage
and
Electromagnetic Compatibility
this vending machine KORI NTO was
tested and certified by
I MQ
, a certifying body authorised by ministerial decree at European level
.
I t is therefore prohibited (on pain of voiding the warranty and the responsibility of the certification) to
replace any electrical component with non-original parts during the routine and extraordinary maintenance
operations.
Therefore it is also prohibited to:
Tamper with or deactivate the safety systems installed in the vending machine.
I nstall the vending machine outdoor or in any case in a place that is not protected from the weather.
Use the vending machine for purposes other than those indicated in the sales contract.
Connect the vending machine by means of extension cords or multiple sockets and/ or adapters.
Use water jets for cleaning.
Then, it is also compulsory to:
Verify the conformity and suitability of power supply line and of the power outlet.
For safety purposes, three different operators with different qualifications have been defined.
USER
The user is practically the final user who buys the products from the machine.
The user must not have any access whatsoever to the inside of the machine.
PERSON RESPONSI BLE FOR REFI LLI NG AND ROUTI NE CLEANI NG
The person responsible for refilling has the key for opening the machine and is in charge of the refilling,
cleaning and internal hygiene of the machine.
He must not have any access to energised parts or moving parts.
MAI NTENANCE TECHNI CI AN
The maintenance technician must be a highly skilled person and must be aware of the electrical hazards in
the event of complex technical operations and can operate with the machine switched on and the door
open, using the safety key supplied.
5 – REQUI REMENT FOR THE USERS
