6
Note: affected by the soil composition, as the same material metal in the different
soil, the position of the target ID cursor will change.
Coin depth indication cursor: it contains three grades, namely 1,2 and
3,equivalent to 2”,4” and 6”.It indicates the approximate depth of the 25
¢
silver
in the neutral soil. It’s only the approximate depth. The size and composition of
the target, and the composition of the soil will affect the indication value.
Sensitivity indication cursor: It’s shared with the depth cursor and will turn into
depth cursor automatically when detecting metal. It is divided into three grades,
which is the highest when all are lighted. Using SENS button to adjust.
PINPOINT cursor: Press and hold down the “PINPOINT” button, then the
PINPOINT cursor is lighted, and the detector turns into NON-MOTION mode,
it’s apply to locate the detected object accurately.
Battery power cursor: When all the cursor is lighted it means the power is enough.
While the entire battery indicator is extinct, it’s time to replace the battery right
away.
CONTROLLER
All the controllers are on the panel.
(
See Fig.7
)
Fig.7
Power button: Press power button to turn on. Press again to turn off.
SENS Button: choose the 3 levels with the SENS button. Boot setting is the
middle level (the second level).The highest sensitivity is the third level, when
there is interference, you can set the sensitivity lower properly. In the PINPOINT
mode, the SENS button is useless.
PINPOINT Button: press and hold down the “PINPOINT” button, the detector
converts into the non-motion mode automatically, it no longer has discrimination
ability. At this time, the PINPOINT cursor is lighted, and indicates the signal
strength. The more close to the metal target, the more the strength cursor is
lighted, and louder the sound is, to locate the target location accurately.
Summary of Contents for MD030
Page 1: ...MD030 User Manual...
Page 16: ...15...