SHOUT nano 100 User Guide Version A
Document Number: 451-22013-001A
17 of 44
NAL Research’s defined AT commands
SatTerm software or any terminal emulator software
NOTE: To install the SatTerm software on a computer, refer to the SatTerm for SHOUT
nano 100 manual [5].
3.5
AT
C
OMMAND
M
ODE
For scenarios where computer control of the SHOUT nano 100 is desired, use a computer
attached to the SHOUT nano 100 USB interface through a USB-C cable. For example, the SHOUT
nano 100 can be turned off using the AT command ^SHUTDOWN. If the device is sleeping or in
low power in between reporting cycles, pressing the Power/Enter button turns the SHOUT nano
100 on for 10 seconds. During this time, take the device out of tracking mode and put it into
command mode by entering a sequence three pluses, “+++”. If “+++” is not entered within 10
seconds, the SHOUT nano 100 goes back to sleep. See section 4.2 Modes of Operation for a more
detailed description of the command mode, and see the NAL document AT Commands for SHOUT
nano 100 [1] for a full list of the AT command capabilities.
