NAL Research Corporation (TN2014-001-V1.4.5)
12
user-defined operating profiles during power up with the ATZn command. Again, the active operating profile
will revert back to the user-defined operating profile designated under the AT&Yn command at power reset.
Normal Tracking Mode
Normal Tracking is the mode when the 9602-LP is configured to power up with AT^START1 command or
after transitioning from Command mode to Tracking mode with the AT^TRK command. Normal Tracking offers
a wide range of unique settings as shown in Figure 5. Each setting can be tailored to meet specific applications.
For example, the 9602-LP can be pre-programmed to transmit reports at a fixed interval, to transmit reports
triggered by the internal motion sensor, to transmit reports triggered by the Emergency switch or to transmit
reports triggered by external devices. The “Callable (No)” option is implemented when lowest power
consumption is required because of limited battery capacity. Or “Same Place Skip Reports” is chosen so that
the 9602-LP does not repeatedly send the same location information back to a command center. The remaining
of this section describes Normal Tracking settings.
Figure 4.
Different Operating Modes of the 9602-LP.
Power-up the
9602-LP
Emergency
Tracking
Emergency Button Pressed
or S0 Set to Hi/Lo
Hold Emergency
Button for 3 secs to go
to Normal Tracking or
Command Mode
Normal Tracking
(See Figure 5)
AT^START1
or AT^TRK
Enter +++ to
switch back to
Command Mode
Test
Tracking
S1 Set to Hi/Low
Set S1 to Hi/Lo to
go back to Normal
Tracking
Command Mode:
Input tracking parameters
9602-LP as modem with GPS
AT^START0
(Factory Setting)
Enter AT^TRK to
begin Normal
Tracking
