Nakayama PB7230, Manual

Page: 6 / 51

EN
Attention: Risk of tool damage.
• The tool is not filled with motor or gearbox oil from the factory. Before operation, the fuel tank must be filled.
• Use a mixture of synthetic two-stroke motor oil and unleaded gasoline. Add 30 ml of oil per litre of gasoline.
• Never use oil made for 4-stroke or water-cooled 2-stroke engines as this can cause spark plug fouling, exhaust port blocking or piston ring sticking.
• Mixed fuel, which has been left unused in the fuel tank for a period of one month or more may clog the carburetor or result in the engine failing to operate
properly. Fill up airtight containers with old fuel and keep them in a dark and cool room.
Warning: Fire hazard.
• Always shut off the engine and wait for it to cool down before filling the fuel tank.
1. Unscrew the fuel tank cap and remove it. (Fig. 20-21)
2. Pour in the fuel carefully. Avoid spilling. (Fig. 22)
3. Screw the fuel tank cap back on firmly by hand.
Draining the fuel tank
1. Hold a container beneath the fuel tank cap.
2. Unscrew the fuel tank cap and remove it. (Fig. 20-21)
3. Allow the fuel tank to empty completely.
4. Screw the fuel tank cap back on firmly by hand.
Fig. 20 Fig. 21 Fig. 22
Carry out the following checks before starting the engine:
• Check the tool for leaks.
• Check the tool for visual defects.
• Check that all parts of the tool have been securely fitted.
• Check that all safety devices are in proper condition.
Warning:
• Do not start the unit until it has been completely assembled.
• Always check the unit before operation to ensure that no part is damaged or defective. If a part is damaged or defective, make sure to replace it before
using the tool.
• Before operation, always check the ground and remove all objects which could be thrown by the tool.
PRE-OPERATION CHECK
1. Press the fuel primer bulb more than 5 times. (Fig. 23)
2. Turn the engine switch (1) to the ON position. (Fig. 24)
3. Set the choke lever to the OFF position. (Fig. 25-26)
4. Pull the recoil starter handle to start the engine. (Fig. 27)
5. Wait for a short while and then set the choke lever to the ON position.
Starting the engine
OPERATING INSTRUCTIONS
Fig. 25 Fig. 26 Fig. 27
Fig. 23
Fig. 24
1
WWW.NIKOLAOUTOOLS.GR
6