Nakayama PB7230, Manual

Page: 5 / 51

EN
1. Remove the nut. Line up the two holes of flange and shield, use one screwdriver to hold the flange and turn the socket wrench clockwise, the nut will be
removed.
Fig. 9 Fig. 10
Fig. 11 Fig. 12
1. Fit the blade. Take the outer flange off after removing the nut, then put the blade, outer flange, shield and nut according to the priority shown in figures. Use
screwdriver to hold the flange and tighten the nut securely counter-clockwise.
2. Remove the blade. Use a screwdriver to hold the flange and release the nut. The blade can now be removed.
Blade
2.
Fit the nylon cutting head.
Remove another shield after removing the nut. Still holding the flange, place the nylon cutting head on the shaft and rotate
counter-clockwise, the nylon cutting head is fitted.
3.
Remove the nylon cutting head.
Use a screwdriver to hold the flange and then rotate the nylon cutting head clockwise. The nylon cutting head can now be
removed.
Fig. 13 Fig. 14 Fig. 15 Fig. 16
Fig. 17 Fig. 18 Fig. 19
Warning: Make sure the cutting head is assembled correctly before use.
FUEL
Warning: Fuel is highly explosive.
• Turn off the motor and wait for it to cool down before filling the tank with fuel.
• You must observe all safety instructions relating to handling fuel.
Filling the fuel tank
WWW.NIKOLAOUTOOLS.GR
5