Nakayama 015635, Manual

Page: 8 / 19

8
WWW
.N
AKAYAMA
T
OOLS
.
COM
Starting the machine
WARNING!
Danger from rotating impeller! The impeller will rotate whenever the machine is operated! Never operate this machine
unless the intake cover and machine tubes are properly installed and in good working order!
Danger from thrown dust or debris! Always wear eye protection when operating this machine! Never direct the machine
stream toward people or animals!
Never operate this machine unless all controls are properly installed and in good working order!
WARNING!
The recoil starter can be damaged by abuse!
<Never pull the starter cord to its full length!
<Always engage the starter before cranking the engine!
<Always rewind the starter cord slowly!
Never operate the machine if the tubes are missing or damaged.
Starting procedure
1. Prime the fuel system by repeatedly depressing the fuel primer bulb until no air bubbles are visible in the fuel discharge
line.
2. Cold engine only. Choke the engine by pulling the choke control to the fully extended position (choke is closed)
3. Place the machine on the ground, and hold the machine handle firmly with your right hand.
4. Pull the starter cord slowly until you feel the engine.
5. Start the machine by pulling the starter cord upward rapidly.
If necessary, repeat step 5 two or three
times until the engine starts.
When the engine starts
IMPORTANT
For maximum vacuum performance and operating life, allow the engine to warm before use.
1. Run the engine at idle speed until operating temperature is reached (2 to 3 minutes)
2. As the engine warms, open the choke gradually by slowly pushing the choke control in to the fully retracted position.
3. The machine should now be ready for use.
If the engine dose not start
Repeat the appropriate starting procedures for “hot” or “cold” engine. If the engine still will not start, follow the “Starting a
Flooded Engine” procedure (below).
WARNING!
Incorrect spark plug installation can result in serious engine damage!
Starting a flooded engine
1. Disconnect the spark plug lead, and use the spark plug wrench to remove the
plug in a counterclockwise direction.
Choke rod
2. If the spark plug is fouled or is soaked with fuel, clean or replace the plug as
required.
Fuel discharge line
Fuel primer bulb
Choke rod