32
When disposal of a Spindle is necessary, follow the instructions from your local government
agency for proper disposal of industrial components.
Refer to Brushless Motor and E
3000 CONTROLLER Operation Manuals.
15
. DISPOSAL OF THE SPINDLE
Trouble
Cause
Inspection / Corrective Action
Cannot clamp a
collet holder.
Poor the air hose connection.
Check all threaded joints and re-tighten
if necessary.
The air hose has been
damaged.
Replace the air hoses.
Low air pressure.
Check the Compressor, Air Circuit,
and Regulator.
Tool slippage.
Collet or collet nut are not
correctly installed.
Check and clean the collet and collet
nut. Reinstall the collet and collet nut.
The collet and the collet nut
are worn.
Replace the collet, collet nut and
collet holder.
High run-out.
The tool is bent.
Change the tool.
Collet nut is not correctly
installed.
Secure the collet and the collet nut
correctly.
The collet, collet nut or collet
holder are worn.
Replace the collet, collet nut or collet
holder.
Inside of the Spindle is worn.
Replace the Spindle shaft.
(Return to NAKANISHI dealer service.)
Contaminants inside the collet,
collet nut and collet holder or
the Spindle.
Clean the collet, collet nut and collet
holder or the Spindle.
The Spindle ball bearings are
worn.
Replace the ball bearings.
(Return to NAKANISHI dealer service.)
