Nakanishi E800Z, Operation Manual, Page: 16 / 24

15
１ COM
２ DIR̲IN
３ 5VDC
４ ―
５ ―
６ STOP(+)
７ ―
８ ERR(+)
９ ―
10 GND1
11 VCC
12 LOAD(+)
13 LOAD(-)
14 START
15 ―
16 ―
17 ―
18 ‐COM
19 PULSE
20 ―
21 ―
22 ―
23 VR
24 ―
25 SPEED̲V
Common Input Signal
Source
Rotation Direction
Setting Signal
Base Bias
―
―
Stop Rotating
―
Trip Signal
―
Analog Power Source
Ground
Power Source for
Analog Signal
LOAD Signal
LOAD Signal(Earth)
Rotation Start Command Signal
―
―
―
Trip Signal
Rotation Pulse
―
―
―
Motor Speed Control
Voltage
―
Motor Speed Monitor
Voltage
Common Signal(DIR̲IN,START)
24VDC NO Dipole Moment Input to set Rotation Direction.
Photo Coupler Bias Power Source
Not Used
Not Used
While motor is rotated, Photo Coupler Transistor is ON. When
motor is stopped, Photo Coupler Transistor is OFF.
Not Used
When Errors Occur(Overload , Motor Cord is disconnected)
Not Used
Unit Internal Ground (+10V Ground)
Speed Direction Voltage(VR) Signal Power Source. Output
+10VDC.
Load Signal Output (0-15VDC)
GND(LOAD)
Input 24VDC to rotate the motor.
Not Used
Not Used
Not Used
Common for (Pins 6,8,19)
Rotation Pulse(Photo Coupler Output TTL Level) 24 Pulse Output/ 1 revolution
Output/ 1 rotation
Not Used
Not Used
Not Used
Rotation Speed (0V-10VDC Input) At 10V, 50,000min
-1
or 80,000 min
-1
Not Used
When motor is rotated, Motor Speed can be monitored.
Output voltage is proportional to motor speed.
Input
Input
Input
―
―
output
―
output
―
output
output
output
output
Input
―
―
―
output
―
―
―
―
Input
―
output
Common
ON(24V);
Reversed Rotation
5VDC
―
―
OFF(OPEN):Stop
―
ON(Closed):Trip
―
Internal GND
10VDC
0-15V Output
GND
ON(24V):Rotation
―
―
―
ON(24V):Trip
24Pulse/Rotation
―
―
―
0-10VDC
―
0-8VDC
②
（1）DIR̲IN (Rotation Direction Setting Signal) and START (Rotation Start Command Signal) (CN2:
Pin1,Pin2, Pin14)
Pin１ ：Common for Pin 2 & Pin 14
Pin２：When +24V DC is supplied to the Rotation Direction
Setting Signal (DIR̲IN), Motor rotates
counterclockwise. When Pin2 is disconnected or
voltage is not supplied, Motor rotates clockwise.
Pin14：When +24V DC is supplied to the Rotation Statrt Command
Signal (START), the motor starts rotating, If 0V DC is
supplied or if the line is disconnected the motor stops.
Com can be either (+) or (-), if using (+) common use (-) on
Pins 2 and 14.
24V (10mA×2 circuits) is needed for power source.
Pin14
（START）
3KΩ
3KΩ
510Ω
510Ω
Pin1
（COM）
Pin2
（DIR̲IN）
①
（ ）