41
42
memo
When the system is shipped from NAKANISHI’s factory all parameters.
~ are set to
(4) Default Parameter Settings
On power up the system will resume all the Control Panel settings in the position they were
in when the system was shut off.
The following settings will be maintained :
1. Motor Speed
2. Rotating Direction (FWD., REV.)
3. Control Mode (AUTO, MANUAL)
4. Gear Ratio Setting
5. Parameter Settings ~
(5) Control Panel Setting Resume Function
Confirmation of the Parameter Settings
•Allows user to check the settings of the above parameters ~
Procedure
1. Push the Start Switch.
2. Display oscillates between and the setting for or
3. Push the Start Switch.
4. Display and oscillates between and the setting for or
5. Push the Start Switch.
6. Display oscillates between and the setting for or setting motor speed (For
example, display 30 for 30,000 min
-1
)
7. Push the Start Switch.
8. Display oscillates between and the setting for or Max. motor speed.
9. Push the Start Switch.
10. Display oscillates between and the setting for or
11. Push the Start Switch.
12. Display oscillates between and the setting for or
13. Push the Start Switch.
14. Display oscillates between and the setting for or
15. Push the Start Switch.
16. Return to setting Parameter or push Error Reset Switch to finish.
8
E3000C̲K0446E̲e̲080108 08.1.8 6:35 PM ページ41
