22
▲Setting Error Output Mode
・Allows setting of the output signal on PIN No.8:ERR of Input/Output Connector A.
・When an error occurs the output can be set to ON(Closed) or OFF(Open).
Procedure） 1. Push the Start Switch
2. is displayed. This indicates that when an error occurs the output will be
OFF(Open).
3. Push the Start Switch
4. is displayed. This indicates that when an error occurs the output will be
ON(Closed).
5. You can cycle through the choices by pushing the Start Switch.
6. Push the Reset Switch to send the settings to memory will be displayed
depending on the position of the potentiometer.
7. If you desire to set other parameters turn the potentiometer to select the parameter to
be set.
8. If you are finished setting parameters, turn the Power Switch off.
If the Error Output Mode has been changed from the default setting,
that setting will be displayed the next you enter Parameter Setting Mode.
▲Setting AUTO Mode Motor Speed Control
・Allows the setting of the manner in witch motor speed can be controlled when the system is being
used in AUTO mode (External Command Signal Control).
・This parameter selects between speed control with the Motor Speed Adjustment Switch or by
External Command Signal through Input/Output Connector A .
Procedure）1. Push the Start Switch
2. is displayed. This indicates that speed control is by External Command
Signal Control and the Motor Speed Adjustment Switch are Disabled.
3. Push the Start Switch.
