15
after receiver is powered off. This facilitates easy setup by enabling quick selection of
stored channels for any group, i.e, selecting any group will automatically display the
last channel selected for that group. See section “11. U-800 Frequency Lists”
for available channels in each group. The previous group and channel used is stored
in memory automatically when receiver and transmitter are turned off after operation.
Selecting a different group on the receiver in subsequent use will display a differ-
ent channel as previously selected for that group, however, the transmitter will need
again to be sync’ed to that new frequency to complete the system setup for operation.
Receiver ASC/IR Sync GR/CH (Frequency)
If different frequencies than previously stored in both the receiver and transmit-
ter memories are needed, there are three ways to program the receiver and then
sync the selected Group/Channel to the transmitter: One-Touch Automatic ASC™/
Auto Sync receiver to transmitter, manual SCAN for Group/Channel, or manual
select Group/Channel from the Factory preset or User Selectable channel. place the
transmitter’s IR RECEPTOR SENSOR WINDOW (37, 44) 6-12” away from the
receiver’s IR WINDOW (4) before starting the following steps.
• For One-Touch channel Autoscan and Automatic ASC™/Auto Sync from the
receiver to the transmitter, press the MENU BUTTON (18) once, wait for about
5 seconds, the receiver will start process automatically with no further user action
required. A running bar in a clockwise direction on the LCD DISPLAY (5) shows
the scanning process which normally takes about two seconds. When it finds an
interference-free channel, the receiver stores the channel for use, and it will begin
ASC™ sync IR download of the selected channel to the transmitter automatically.
• To manually scan the selected Group/Channel, press the MENU BUTTON (18) twice
for AUTOSCAN menu, press UP BUTTON (16) once and it will start scanning. A
running bar in a clockwise direction shows the scanning process, which normally takes
about 2 seconds. When it finds an interference-free channel, it will display and store the
frequency/channel for use. It can be rescanned again for a new frequency by pressing
the Up button or pressing the MENU bUTTON twice to IR MENU (IR icon will lit up for IR
function), then pressing Up bUTTON to start IR programming.
• To manually select Group/Channel press the MENU BUTTON (18) once for
GROUp (11) selection for Factory pRESET Group 11 to 1A mode or User SELECT-
AbLE Group 1b to 1F mode. Use the Up/DOWN buttons to change the group. Af-
ter selecting a group, press the MENU bUTTON twice for channel selection menu.
Use the Up/DOWN buttons to change the channels (frequencies) that are avail-
able in each group. [Note: for Group11 to 1A, the CH (12) display will indicate
the channel number chosen, and for Group 1B to 1F only the letter “U” and the
frequency chosen will be displayed. See section “11. U-800 Frequency Lists”
for available channels in each group]. After finishing channel selection, press the
MENU bUTTON once or wait a few seconds for IR MENU, and then press Up bUT-
TON to start IR programming.
This completes the GP/CH (frequency) programming. The next section outlines the
procedure for sync’ing the receiver’s programmed channel to the transmitter.
