ENCORE DUET RECEIVER
5
1. Rackmounting the Receiver
There are 2 options available for rackmounting the Encore DUET receiver: singly or
side-by-side with another Encore Series receiver.
a. Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from each side of
the receiver (as shown) and slide in the optional ERM-12 RACK EARS (9).
b. Side-by-side double mounting: After removing the SIDE MOUNT CLIPS (1) from
both Encore receivers, join the two receivers with the EJC-2 JOINING CLIP
(10) and attach the ERM-22 RACK EARS (12) as shown.
(Note: Do not mount
the receiver in a rack directly above an amplifier or other source of high
heat – this could degrade the performance of the Encore DUET. Always
ensure adequateairflow and heat dissipation in any rack configuration.)
2. Powering the Receiver
Plug the 12V AC/DC ADAPTER (15) provided into the DC INPUT JACK (11) on the
back of the receiver. Then plug the power supply into an AC outlet.
(Note: Any 12V DC source with 400mA capability can also be used.) Press
the POWER SWITCH (8) once to turn on the receiver. The POWER ON LED (7)
will now light and the receiver is operational.
3. Antennas
The Encore DUET receiver is supplied with TELESCOPIC ANTENNAS (16), one each
for Channel A and Channel B. These should be extended fully to obtain maximum
range. Optimal antenna position is 45 degrees from the receiver (at 90 degrees
from each other). For maximum range, it is always best to maintain a line of sight (no
obstructions) between the receiver antennas and the transmitter at all times whenever
possible.
4. Mute (Squelch) Adjustment
In normal operation, the MUTE CONTROLS (2) for each channel (A & B) should be
set fully counterclockwise to the factory preset minimum RF level. However, in areas
of high RF activity, the mutes (or squelches, as they are sometimes called) may need
to be adjusted to compensate for the adverse conditions in a particular location. If,
with the transmitter off, one or more LEDs of the receiver's 5 LED RF LEVEL DISPLAYS
(4) for that channel transmitter flicker or stay on, the squelch control for that channel
should be turned clockwise until the LEDs extinguish. When the squelch is properly
adjusted, the RF LEVEL LED displays will only light when that channel transmitter is
turned on. Turning the squelch control too far clockwise will reduce the range, but
yield a quieter mute (squelch) function. When the 5 LED RF LEVEL display extinguish-
es, the transmitter for that channel is out of range for that given location, and the user
should move closer to the receiver to re-establish the radio link.
38
XLR Connector – Connects microphone to the transmitter module for signal input
Locking Ring – Locks microphone to the transmitter
Optional Pouch – For lavalier bodypack operation (with beltclip and strap ring
for securing)
Gain Control Switch – Adjusts the input sensitivity (LO or HI)
Low Battery LED – Single flash (power on), lit steady (low battery)
Power Switch – Turns the power ON/STANDBY/OFF. In standby position, the
power is on and the audio is off.
Phantom Power ON/OFF Switch – Turns the phantom power ON/OFF
Battery Compartment
Release Button – Press to release XLR connector
9V Alkaline Battery
36
37
38
39
40
41
42
43
44
45
16
44
36
37
43
41
42
40
39
45
