C O N T R O L S A N D C O N N E C T I O N S
Assign switches (38) are depressed) and the TAPE Input. The
level of signal routed to the L-R Master faders (24) from tape
decks, CD players, etc., input to the Tape Input (21) is determined
by the Tape In Level Control (33). The 10-stage LED Output
Meter (34) can be selected with the Meter Select Switches (35) to
display the Master Mix output level.
d. Monitor Function and Operation
(19) CONTROL ROOM OUTPUTS
(23) HEADPHONES OUTPUT
(28) PHONES/CONTROL ROOM CONTROL
(29) PFL MONITOR SELECT SWITCH
(30) L-R MONITOR SELECT SWITCH
(31) G1-2 MONITOR SELECT SWITCH
The CMX-16A allows you to monitor singly the L-R Main Mix , the
G1-2 Group mix or the pre-fader PFL signal by selecting one of the
appropriate Monitor Select switches (29,30,31). The level of the
selected signals is adjusted with the Phones/Control Room con-
trol (28) and routed to both the Control Room (19) and
Headphones (23) outputs. The L-R Control Room Outputs (19)
can be connected to an amp to power stereo control room (or
other) monitor speakers and are 1/4" unbalanced phone jacks,
wired: Tip = positive (+), Sleeve = ground. The Phones Output will
feed headphones and is a 1/4" TRS jack, wired: tip = left signal,
ring = right signal, sleeve = ground.
e. Power Switches
(40)
AC POWER IN SOCKET
(26)
MAIN POWER SWITCH
(26A) POWER ON LED INDICATOR
Once the external PSU is connected to the AC Power In Socket
(40) and then to the AC power source, you may switch on your
mixers with the Power On switch (26). The Power "ON" LED
(26A) will light up. Allow 1 minute after powering up for the system
to reach equilibrium before setting inputs gains and other levels.
(27)
PHANTOM POWER SWITCH
(27A) PHANTOM POWER ON LED INDICATOR
When using condenser mics, +48VDC can be switched globally on
or off to the XLR mic inputs for all mono channels (also see MONO
INPUT SECTION, MIC INPUTS). When this switch is in the "ON"
position, The Phantom Power On LED Indicator (27A) will light,
and +48VDC will be provided between pins 2 and 3 of all the mono
Mic input XLR connectors (Ch 1-8). If you don’t need phantom
power, be sure to turn this switch to the "OFF" position.
[Note: It is safe to connect balanced dynamic mics or line level
devices even if this switch is on, but connecting unbalanced
devices or devices whose transformers are center-grounded will
cause hum or malfunctions. Shorting the +48VDC can also dam-
age your mixer. Also, mute the Monitor/PA speakers when turning
the phantom power on or off.]
(29)
(30)
(31)
(33)
(32)
(25)
(28)
(27A)
(27)
(26)
(26A)
11
BACK PANEL
(40)
