NADEX MDM22-M01A, Instruction Manual

Page: 17 / 32

11 / 24
Selection of Menu Function
5. Selection of Menu Function
5-1. How to select
(1) Press the [MENU] key to switch measuring mode to menu mode, and the following display will
appear:
(Example of a display)
(2) To change the item, press the [MENU] key to go on to the next item.
(3) After selecting the item to be set, move the cursor to the desired setting value by the [SEL.] key.
(4) For further setting of other items, repeat (2) to (3).
(5) On completion of setting all the necessary items, press the [DISP] key to switch menu mode to
measurement mode and start measurement. It cannot measure in menu mode.
5-2. Selection Menu Items
(1) Selection of welding method
There are two welding methods to select from, namely, AC welding, DC welding .
AC : When measurement is made with a single-phase AC welder.
DC :When measurement is made with inverter controlled welder and AC inverter controlled welder.
(Example of a display)
Caution
- The tip voltage of AC inverter welding machine cannot be measured.
(2) Selection of frequency
The local power frequency must be selected.
There are two frequency to select from, namely, 50Hz and 60Hz .
(Example of a display)
Caution
- When this setup is changed, all the measurement data memorized by the
memory is eliminated
- In cyc measurement, any frequency other than 50Hz and 60Hz cannot be
measured.
W E L D M E T H O D A C
F R E Q U E N C Y H z 0 6
W E L D M E T H O D D C