ADJUSTMENT HEIGHT SQUEEGEE SUPPORT
Figure 13
The squeegee has to be regulated in height depending on the wearing
of the rubbers. To adjust this it is necessary to act on the knobs
(1):
- By rotating clockwise the squeegee raises;
-
By rotating counter-clockwise the squeegee lowers. It is
important that the right and left little wheels are set at the same
height, only in this way the squeegee can work parallel to the
floor.
ASSEMBLY OF WASHING OR WASHING/SCRUBBINGUNIT
Figure 14
The machine is supplied as a base unit. Their are two different
washing units available, to be chosen according to the type of floor
and its conditions:
1.
Washing unit with brushes. Suitable for all types of floor, and
used for routine maintenance scrubbing. Also can be used for
aggressive scrubbing, cleaning, and stripping by increasing
pressure.
2.
Washing & sweeping unit with cylindrical brooms. Suitable for
rough, uneven, and grouted surfaces. Will scrub and sweep
debris in one pass and collect the solid debris into a hopper
without obstructing the squeegee rubbers.
WASHING UNIT ASSEMBLY
(brushes)
Figure 15
1.
Loosen the knobs (1) from the horizontal pins on the left side of
the units and rotate them outwards.
2.
Position the base under the machine into the proper controls (2)
3.
Rotate the knobs toward the inner part of the base and stop
them.
4.
Connect the quick water coupling (3).
ADJUSTMENT HEIGHT SPLASH GUARDSRUBBERS OF
THE WASHING UNIT
Figure 16
During working operation the base splashguards rubbers must skim
over the floor.
1.
To vary the height of the support, and therefore of the
splashguards rubbers, the horizontal knobs (1) must be screwed
or unscrewed.
2.
After regulating correctly the rubber height, stop the knobs.
- 6 -
