Noralsy™ Keypad
30 Codes / 1 Relay
SET-UP ON INSTALLATION
Wire up according to appropriate electrical schematic for your installation, then power up the unit.
Flick the programming switch SW1 and wait for unit to start beeping every 3 seconds.
SET THE MASTER CODE. IT MUST BE STORED IN SLOT 06.
Example:
You want the following MASTER CODE: 74AB6
After a beep enter on the keypad:
06
5
74AB6
Master Code Slot Number
Length of Code
Master Code Itself
If you have correctly entered the Master Code you will hear 2no. series of rapid beeps.
Turn off Programming Switch SW1. You can now effect all programming simply by entering the Master Code and waiting for the
programming beeps.
TOP POINTS TO REMEMBER
1.
Up to 29 user entry codes available at any one time.
2.
Codes are stored in slots numbered 01, 02, ....05 and 07, 08......30.
3.
Master Code = Programming code and must be stored in Slot 06.
4.
Each code can be any mix of digits/letters from 3 to 8 in length.
TIP - WHEN YOU ARE PROGRAMMING
Enter the numbers in quick succession after a beep. Do not wait more than 2-3 seconds in between entering numbers as this will
confuse the keypad. If you have correctly programmed, you will hear a rapid series of beeps.
SETTING USER DOOR ENTRY CODES
Enter the Master Code onto the keypad and wait for the beeps.
Example: you want the following codes:
A94
= 3 digits
564B52
= 6 digits
After a beep enter on the keypad:
01
3
A94
Slot Number
Length of Code
Code Itself
02
6
564B52
Slot Number
Length of Code
Code Itself
NOTE CAREFULLY:
No codes into slot no. 06 as this is for the Master Code !
(Unless, of course, you want to change the Master Code).
Press B to escape from programming.
DELETING USER DOOR ENTRY CODES
As all door entry codes are stored in slot numbers 01 - 05 and 07 - 30, it is easy to delete a code from the system.
NOTE CAREFULLY
- Do not delete slot no. 06 unless you are going to input a new Master Code whilst still in programming mode !
Example - Your codes are:
A94
for Mr Smith
stored in Slot 01
564B52
for Staff use
stored in Slot 02
To delete Mr Smith’s code - A94 - from the system simply:
Enter the Master Code onto the keypad and wait for the beeps.
After a beep enter on the keypad:
01
A
Slot Number
Delete Command
Press B to escape from programming.
Note 1.
You do not have to know the actual code itself which needs to be deleted, only the slot in which it is stored.
Note 2.
Capacity is never reduced as a result of deleting codes. You can always add or change codes.
SETTING LOCK OPEN TIME
Enter the Master Code onto the keypad and wait for the beeps.
Lock open time can be set at
0.2
seconds or
01 - 99
seconds.
After a beep enter:
00 00
for 0.2 seconds (automation control)
00 05
for 05 seconds
00 10
for 10 seconds
00 19
for 19 seconds etc
Press B to escape from programming.
If you do not press B to escape from programming, the keypad automatically reverts to normal mode after 20 seconds.
13
NORALSY
™
MASTERING ACCESS CONTROL
™
™
