81-SS30048a
- 15 -
7-4-2 Replacing the Tire (Method B)
(1) Push the side of the tire and put off a jut on the inner of the tire from the wheel body.(Figure14)
(2) In such situation, pushing the tire to lateral side, remove the tire from the wheel by rotating the wheel gradually.
(Figure15)
(3) Prepare a new tire to be replaced (Figure16). Put a jut to inset a ditch of the wheel first, and then put whole of
the tire to inset the wheel completely by rotating the wheel.(Figure17
）
(4) Confirm whether the tire entirely fits to the wheel without gap between the tire and the wheel.(Figure18-21)
(5) Verify whether the speed control function works properly.
・
In replacing the rubber tire, be careful that your hands will not injure between the tire and the wheel and/or
between the wheels and the frame of the rollator.
・
This procedure shall be done in the condition that the rear wheel attaches on the frame of the rollator.
Working with detaching the wheel from the rollator would cause to failures of the product.
Figure 13
WARNING
CAUTION
