Magnum IV Control Manual for Gyro Tech Swing Door Systems
Page 2
www.NabcoEntrances.com
1/4/06
CAUTION
Read these safety practices before installing, operating or servicing the automatic door. Failure to follow these
practices may result in serious consequences.
Read, study and understand the operating instructions contained in or referenced in this manual before operating.
If you do not understand the instruction, ask the installing qualified technician to teach you how to use the door.
This manual and the owners’ manual must be given to and retained by the purchasing facility or end user.
If the door appears broken or does not seem to work correctly, it should be immediately removed from service and
a qualified service technician contacted for corrective action.
Disconnect power at the fused disconnect during all electrical or mechanical service. When uncertain whether
power supply is disconnected, always verify using a voltmeter.
All electrical troubleshooting or service must be performed by qualified electrical technicians and must comply
with all applicable governing agency codes.
It is the responsibility of the installing door technician to install all warning and instructional labels in accordance
with the applicable ANSI standard.
It is the responsibility of the purchasing facility or end user to keep warning and instructional labels and literature
legible, intact and with the door.
Replacement labels and literature may be obtained from local NABCO ENTRANCES INC. authorized
distributors. If the name of the local distributor is unknown, contact NABCO ENTRANCES INC. at (877-622-
2694) for assistance.
Do not place finger or uninsulated tools inside the electrical control box. Touching wires or other parts inside the
enclosure may cause electrical shock, serious injury or death.
All adjustments should be made with a small screwdriver. DO NOT use a pencil.
The ground wire from the Magnum 120 VAC harness and the ground wire from the 120 VAC “in” line must be
attached to the ground screw which is located in the header.
Final installation must conform to current versions of ANSI 156.19 for Low Energy swingers or ANSI 156.10 for
Full Automatic Installations.
