14 of 26
GT1400 Standard Single/Hurricane Single Folding Door Installation Manual
www.NabcoEntrances.com
P/N C-00177
Rev 6-14-21
3. Go to the PIVOT side of panel at the BOTTOM.
1. Measure (6) inches across from the Pivot End of Bottom Rail, towards the Strike Stile. Mark that spot.
2. Measure (6) inches up from the Pivot End of Bottom Rail, towards the Top Rail. Mark that spot.
4. For each marked spot, place (1) Setting Block (not provided by NABCO) on top of the Base Glass Stops.
5. Place the Glass Panel up against the Vinyl and sits on top of the Setting Blocks.
6. Shift the Glass Panel until it is square.
7. Secure the Glass Panel with Snap-In Glass Stops (Provided by Nabco).
DN 1699
Glass Panel
6”
6”
6”
6”
Top Rail
Bo om Rail
Pivot S le
Strike S le
Se ng Block
Top Se ng Block
Se ng Block
Base Glass Stop
M-60255
M-70255
Snap-In
Glass Stop
M-60338
M-70338
Glass Panel
Example Shown:
1/2” Tall, 1/4” Glass
1/2”
Vinyl
M-00339
Figure 20
Install Glass inside Door Panels
