11 of 26
www.NabcoEntrances.com
GT1400StandardSingle/HurricaneSingleFoldingDoorInstallationManual
Rev 6-14-21
P/N C-00177
Figure 12
Release Spindle Drive Bar from Guide Channel
DN 0844
Nut
Guide Channel
Spindle Drive Bar
Bolt
Spindle Drive Bar - 90 Out
(Lowered down from Header)
Guide Channel
90
Section 9 .4 Secure Folding Door to Frame
1. With the Folding Door still on a flat surface, go to the Pivot End of the Top Web.
2. Remove (4) 1/4-20 x 3/4 inch Hex Head Screws and (4) 1/4 inch Star Washers from Riv-nuts located inside the Web.
Figure 13
Remove Screws and Star Washers
DN 0845
1/4” Star Washer
1/4-20 x 2”
Phillips Head Screw
Web
3. Lift the Folding Door from the flat surface. Keep Door Panels loosely folded.
4. Tilt the Folding Door to slide the Spindle Drive Bar into the Pivot end of Top Web. The Spindle Drive Bar can be pushed up
toward the Header to allow clearance.
5. Upright the Folding Door to slide the Bottom Pivot onto the Pivot Bearing located inside the Bottom Rail.
6. Go back to the Top Web. Lower the Spindle Drive Bar until it butts up against the Web.
7. Secure the Spindle Drive Bar to the Web with (4) 1/4-20 x 3/4 inch Hex Head Screws and (4) 1/4 inch Star Washers that were
saved for reinstallation.
a. Do not tighten down bolts at this time. Bolts need to be loose enough to allow the Folding Door to be adjusted.
Figure 14
Install Folding Door
DN 0992
Spindle
Drive Bar
Pivot Bearing
1/4” Star Washer
1/4-20 x 3/4”
Phillips Head Screw
Section 9 .5 Secure Guide Channel to Folding Door
1. Manually hold open the Folding door while removing the Pin or 1/8 inch Allen Wrench from the Coupling Access Hole.
2. Swing out, and then lift the Guide Channel so it is directly on top of the Guide Roller located inside the Top Web at the Strike
end. Drop the Guide Channel onto the Guide Roller. Allow the Folding door to close without slamming closed.
