(Revised 4-9-2013) NT24k Managed Industrial Ethernet Switch User Manual & Installation Guide Page 25 of 132
USB INTERFACE
The NT24k switches provide a USB interface accessed via the USB connector labeled as “USB” on the
back of the unit near the center. This is used to access the Command Line Interpreter (CLI) or PPP (
Point-
to-Point Protocol
). PPP allows any configuration and status that the browser does.
USB Cable
Connect the USB port of your PC and the Switch using a standard USB cable. You will require a cable with
a Type A connector for the PC end, and a Type B connector for the Switch end.
Standard USB cables are readily available from a variety of computer stores.
HyperTerminal
The following configuration should be used in HyperTerminal:
Port Settings:
115200
Data Bits:
8
Parity:
NONE
Stop bits:
1
Flow Control:
NONE
