Revision 050908
Page 14 of 101
SERIAL INTERFACE
The 708 Series switches provide an EIA-232 interface accessed via a 9-pin female connector (labeled
‘COM’ on the unit). This is used to access the Command Line Interpreter (CLI). The pin-outs are shown
below:
Serial Cable
Connect the serial COM port of your PC and the 700 Series Switch using a standard straight through serial
cable. You will require a cable with a 9-pin or 25-pin sub-D female connector for the PC end, and a 9-pin
male sub-D connector for the 708 Series end.
The following table shows the pin-out and the connections for both types of cable:
PC Port
25-Pin
9-Pin
708 series
Female
Female
9-Pin Male
Signal Name
Pin #
Pin #
Pin #
Signal Name
TXD 2
3
3
RXD
RXD 3
2
2
TXD
GND 7
5
5
GND
Standard straight through serial cables are readily available from Radio Shack or a variety of computer
stores.
HyperTerminal
The following configuration should be used in HyperTerminal:
Port Settings:
115200
Data Bits:
8
Parity:
NONE
Stop bits:
1
Flow Control:
NONE
