(Revised 2013-06-21)
35
When VLAN is enabled, all ports are members of VID 1 by default. If you enter ‘group2’, for example,
you’ll be asked to enter (in decimal) a VLAN ID (VID) in the range of 1 through 511. Then, you’ll be asked
to enter the ports that are to participate in that tagged VLAN. Then, you’ll be asked if all these ports are to
have that VID as their PVID or not. Then, you’ll be asked if you want outgoing packets to be untagged for
all these ports or not. The defaults used on pressing <enter> without a value are denoted by parentheses, as
in “(YES)”.
Example of the Tagged VLAN config ( groupX ) screen, taking default choices:
Note that for the defaults choices (just enter) all chosen ports have the group VID as their PVID,
and outgoing packets are untagged for all group ports.
CLI\SWITCH\VLAN>group2
Configure Tagged VLAN Group 2.
Enter VID or <(ESC)> to exit> 215
Enter ports to Join VLAN Group 2
(Example: '3,6,12,14<enter>'.)
Enter Port Numbers (or ESC to exit)> 2,6,17
These ports were removed from group1: 2 6 17
Would you like all these ports to have PVID=215 ?
Enter 'NO' or (YES):
CLI>
For incoming pkts with tagged VID=215, the outgoing pkts are untagged
for ports: 2 6 17
Do you want to change this ?
Enter 'YES' or (NO):
CLI>
CLI\SWITCH\VLAN>
