6
Working with the B5 Deburring Device
The motor has a speed governor which can be used to adjust the speed to the relevant material. Infinitely variable from
6,000 to 10,000 min
-1
.
The ON/OFF switch is located on the handle.
Do not start working on the job until the correct speed has been reached.
Work on material.
When bevelling or deburring, the device must always be guided from left to right (up-cut
milling).
Operation with the device in all positions must be carried out with both hands.
Switching Off
1. Withdraw device from material.
2. Operate ON/OFF switch, the motor is turned off.
Attention:
Perform regular wear checks on cutting inserts. Sharp cutting inserts ensure efficient cutting performance and prevent
device from damage. Ensure to rotate or replace blunt or cracked cutting inserts when due.
Maintenance Intervals
Transmission and gearhead:
Lubrication carried out by a specialist at every 100 operating hours or replace
lubricating grease.
Recommended grease:
Grease off the type MSN 2 (Rhenus Norlith)
The first gear chamber needs to be filled up with 20 g
and the gear chamber on the motor side with 17 g.
Mounting thread on
Clean and lubricate as necessary.
transmission housing:
Motor air vents:
Clean as necessary.
Cutting inserts:
Rotate or replace as necessary.
Ball bearing race:
Replace as necessary.
Tool change:
Push the shaft lock on the motor to the side and rotate milling head counter-
clockwise. Completely remove cutting insert holder.
