N-Com M5, User Instructions And Safety, Page: 19 / 32

M5
19
14. SETTING MODE
All Bluetooth pair ups and other adjustments are carried out in this mode.
To put the system in Setting mode (system turned off), press the “
BACK ” key and keep it pressed for 4
seconds, until the red LED starts to flash quickly.
n
on
N
+
on
▲ ▼
▲
+
▼
BACK
Turning on/off the RDS x1
Turning on/off the Smart Navi System 2 sec
Pairing up Secondary Phone 2 sec
Pairing up CHANNEL 1 x1
Pairing up CHANNEL 2 x2
Pairing up CHANNEL 3 x3
Pairing up CHANNEL 4 X
Pairing up CHANNEL 5 x2
Pairing up CHANNEL 6 x3
Pairing up the wireless keypad 10 sec
Reset 4 sec
*With Friends Configuration active.
15. BATTERY AND RECHARGE
15.1. Low battery signal
During its operation, the system alerts the user with a voice message when the battery is low. From
the first message, the system has a 1-hour autonomy. Warning is given every 10 minute.
15.2. Charging the system
To charge the system, hook it up to the battery charger or to a USB outlet powered with the USB-mini
USB cable supplied as standard equipment. The charge will take place as follows:
Fig. 22
When you connect the M5 system to the
battery charger, the red LED of the
Emergency Stop Light stars to flash (at a
frequency of 10 seconds).
When the battery is fully charged, the red
LED turns off.
N.B. : If the device has not been charged for a long time (a few months), it may not be possible to turn
on the system during the first few minutes of the charging, as the voltage may drop below the
minimum limit.