Usage Recommendations
1. For best result, the fall sensor should rest at the center of the user’s breastbone.
2. Wear the fall sensor on the outside of all articles of clothing.
3. Carefully place the fall sensor on a table or nightstand when you are not using it in order to avoid activating the
pendant.
Sending a HELP Alert signal
- To send a HELP ALERT signal to the PERs, press and release the HELP button on
the face of the myActive alert+. The LED will illuminate Green.
The Lights-
LED OFF= Standby mode
1 Red flash, 1 Green flash= Exit shipping mode
1 Green flash=
Transmitting via button or fall signal (Battery Good).
1 Red flash=
Transmitting via button or fall signal (Battery Low).
Battery monitoring- The myActive alert + periodically monitors the internal battery voltage. If the voltage is below a
certain threshold, a LOW BATTERY signal is transmitted to the PERS. Once a low battery is reported, the myActive
alert + should be replaced within XX weeks.
Replacing the battery-
1- Use a small Philips head screwdriver to remove the back battery cover.
2- Insert the replacement battery (CR2477) with the positive side (+) of the battery is facing outward.
3- Replace the back battery cover.
4- DON’T FORGET TO EXIT SHIPPING MODE any time you replace the battery!
Adjusting the lanyard
Gently slide one side of the neck cord thru the adjuster bracket (3) shown in figure 1. Although the lanyard may be
increased or decreased in size, for best performance the button should rest at the center of the user’s breastbone.
Supervisory mode
To place the myActive alert + in supervisory mode, press the pendant 5 times quickly (within 3 seconds) the LED
will flash GREEN.
To exit the supervisory mode, press the pendant 7 times quickly (within 3 seconds) the LED will flash RED.
YTREX
inc.
SYNERGY BY DESIGN
TM
Dealer Support
877.801.6551
