4
Important Safety Information
Please read and understand this manual completely
before operating this machine.
Grounding Instructions
This machine must be grounded. If it should malfunction
or break down, grounding provides a path of least resis
-
tance for electrical shock. This machine is equipped with
a cord having an equipment-grounding conductor and
grounding plug. The plug must be plugged into an appro
-
priate outlet that is properly installed in accordance with
all local code and ordinances. Do not remove ground pin; if
missing, replace plug before use.
Improper installation of the equipment-grounding
conductor can result in a risk of electric shock. Be sure to
check with a qualified electrician or service person if you
are in doubt as to whether the outlet is properly grounded.
If the plug will not fit in the outlet do not modify the plug or
the machine’s cord, instead have a proper outlet installed
by a qualified technician.
This machine is for use on a nominal 120-volt circuit and
with a grounding plug similar to the one in Figure 1 below.
If a proper outlet is not available, follow the illustrations
of Figure 2 & 3 to install a temporary-grounding plug. This
temporary work-around should be used only until a proper
outlet (Figure 1) can be installed by a qualified electrician.
When and if this type of adapter is employed, screw the
adapter’s extended tab into place with a metal screw.
However, grounding adapters are not approved for use in
Canada.
Again, be sure to check the grounding pin for damages
and replace if necessary.
The Green, or Green-Yellow, wire in the cord is the
grounding wire. When replacing a plug, this wire must be
attached to only the grounding pin.
DO NOT use extension cords.
Please Note for America use only.
Parts and Service
Please contact Mytee service personnel or a Mytee au-
thorized Service Center using Mytee original replacement
parts and accessories if repairs need to be performed.
When and if calling Mytee for support, please have your
Model and Serial Number available for faster assistance.
Name Plate
The Model and Serial Number are located on the lower half
of the back of the machine near the power plug and will be
required for ordering replacement parts. You can use the
space provided in this manual to note down both for future
referencing.
Unpacking the Machine
When your new machine is delivered, please carefully
inspect both the shipping carton and the machine for
damages. If damage is evident, save both the shipping
carton and machine so that the delivering carrier can
inspect it. Contact the carrier immediately to file a freight
claim if there has been any damage.
Caution and Warnings
Symbols
Mytee uses the symbols below to signal potential
-
ly dangerous conditions. Always read this informa-
tion carefully and take the necessary steps to protect
personnel and property.
Is used to warn of immediate hazards that will cause
severe personal injury or death.
Is used to call attention to a situation that could cause
severe personal injury.
Is used to call attention to a situation that could cause
minor personal injury or damage to the machine or other
property. When using an electrical appliance, basic
precautions should always be followed, including the
following: Read all instructions before using this machine.
This product is intended for commercial use only.
To reduce the risk of fire, electrical shock, or injury:
1.
Read all instructions before using equipment.
2.
Use only as described in this manual. Use only manu
-
facturer’s recommended attachments.
Figure 1
Grounding Pin
Grounded Outlet
Grounded Outlet Box
Adapter
Tab for Grounding
Screw
Metal
Screw
Figure 2
Figure 3
