MyQ LiftMaster CAPAC, Installation Manual

Page: 14 / 60

14
PRE-INSTALL NETWORK INSTALL ACCESS CONTROL INTRODUCTION
INTRODUCTION PRE-INSTALL NETWORK INSTALL ACCESS CONTROL
INTRODUCTION PRE-INSTALL NETWORK INSTALL ACCESS CONTROL
INTRODUCTION PRE-INSTALL NETWORK INSTALL ACCESS CONTROL
INTRODUCTION PRE-INSTALL NETWORK INSTALL ACCESS CONTROL
Wiegand Output
NOTE : Disconnect power BEFORE making electrical connections.
The CAPAC will send the pre-assigned credential, configured via
myQ Community, to the TES via the Wiegand output.
INPUT OUTPUT WIEGAND
GATE
SDA SCL
OUTPUT
NO COM NC NO COM NC
1 2
D1 COM D0 D1 COM D0
1 2
WIEGAND
1 GND 2
INPUT
GND 12V-24V
POWER
POWER ETHERNET
Data-0
Ground
Data-1
Data-0
Ground
Data-1
Third Party Access System
Wiegand Input - TES /
Access Control Wiegand
Third Party Access System
Wiegand Input - TES /
Access Control Wiegand
Not responsible for conflicts between the information listed in
the wiring diagram and the requirements of your local building
codes. The information is for suggested use ONLY. Check your
local codes BEFORE installation.
NOTE : For UL installations, only a Listed UL 294 access control
unit may be connected to Wiegand output 1 or 2.