The MyGate Q71S Control Board Installation Manual : Printed 11/02/2013 13:16
15
Selecting the Operating Mode
Before we program the opening / closing cycles, we first need to establish the cycles operating mode.
The operating mode is selected through DS1 dip-switches. The switches are located to the right hand side
of the control board (illustrated right):
There are three different operating modes:
Step by Step
Automatic Closing
Automatic Closing with Multi-occupation
STEP by STEP Mode (Automatic closing turned off)
This operating function turns off the automatic closing. When a START command is given by pressing
remote control button or:
A first START command makes the gate OPEN.
A second START command while the gate is opening will STOP the gate.
A further START command makes the gate CLOSE.
A START command while the gate is closing will STOP the gate.
To select this operating mode place the DS1 dip-switches as shown right:
1=OFF
2=OFF
3=OFF
AUTOMATIC CLOSING Mode
A first START command makes the gate OPEN, once the gate has reached the
complete opening it stops and the PAUSE-TIME starts.
When the pause-time elapses the gate automatically CLOSES.
If a START command is given while the gate is opening, the gate STOPS still.
A further START command makes the gate CLOSE.
If a START command is given while the gate is closing, the gate STOPS and
REVERSES in about 1.5 seconds.
To select this operating mode place the DS1 dip-switches as shown right:
1=OFF
2=ON
3=OFF