myenergi
Pioneer Business Park, Faraday Way
Revision 4.2 June 2022
Stallingborough, Lincolnshire, England, DN41 8FF
D3171
Optional:
Changing Channel
The default channel is number 1 and normally this will not need to be changed, however,
there may be a situation where there is some other device causing interference on a
particular channel.
To change channel:
1.
Press and hold the pair button until the LED flashes blue, the LED will flash rapidly to
indicate the current channel number 1 to 8.
2.
To change the channel, press and hold down the button, the current channel will then
cycle from 1 to 8 indicated by the LED. Once the desired channel is indicated,
immediately release the button.
3.
Ensure all other
myenergi
paired devices are set to the same channel. (Settings >
Advanced > “enter passcode” > Linked Devices > Channel
Step 3:
Configuration
After pairing the
harvi
, the
myenergi
device will need to be configured to use the
harvi
. The
function of the CT’s connected to the
harvi
are also configured via the
myenergi
unit.
1.
On the
myenergi
‘Master’ device, go to Settings > Advanced > CT config
2.
Disable the relevant CT input(s) for that device - this ensures the unit uses the
harvi
CT instead of a wired CT.
3.
Then go to “Advanced Settings” > “Linked Devices” > “Devices”
4.
Highlight the
harvi
device and press (
) or (+)
5.
Configure the CT’s according to the installation. Refer to specific manual for the
myenergi
device you are configuring.
6.
If
harvi
is to be used on a 3-phase installation then ensure you set harvi to “three
phase”. This will automatically set all 3 CT inputs to the same input source e.g. grid,
generation etc. If used on 3-phase make sure that the Net Phases setting on your
myenergi
device is turned on
NOTE
If connecting to older
myenergi
devices (those with serial no. starting with a ‘1’) then only
channels 1,3 & 4 can be used, with the exemption of Australian installs.
NOTE
Please ensure you refer to our GOLDEN CT RULES, which can be found in the all
myenergi
device manuals when connecting the CT’s