Programming
Programming Control Unit CH_SV V00
3/9
1 General
With the control unit you can operate hinged lip and telescopic lip levelers. With this
short description you are able to configure the control unit.
Use for the programming the service tool article- nr.: DS0290020
2 Programming control unit
2.1 Start programming
For starting the programming mode you have to close the door. The control unit needs a
feedback on the terminal X05.
2.1.1 Open programming menu
•
Switch off control unit or lock emergency stop push button
•
Press programming button „2“
•
Switch on control unit or unlock emergency stop button with pressed
programming button „2“
•
Approx. 5s later P00 appears on the display
•
Now the control unit is ready for programming
2.1.2 Select program no.
•
Press programming button „1“ as often as necessary until the wished no. Of the
program is indicated, counting upwards from
P00 to P99.
•
By actuating the programming button „3“ it is possible to scroll backwards
2.1.3 Confirm program no.
•
If the wished program no. Is indicated, press the programming button „2“ once.
The subprogram of the selected program no. flashes
2.1.4 Select subprogram no.
•
Press programming button „1“ as often as necessary until the wished subprogram
no. Of the program is indicated, counting upwards from
U00 to U99.
•
By actuating the programming button „3“ it is possible to scroll backwards
2.1.5 Confirm subprogram no.
•
If the wished subprogram no. Is indicated, press programming button „2“ once.
The selected program no. is indicated
•
The selected subprogram no is stored
either
Select new program no. and change subprogram no. accordingly
or
2.2 Finish programming by
•
Press Programming button „2“ for 5s
•
The display shows the actual operation condition
