original operating instructions mycusini
For questions please contact us at [email protected]
Important
: Rotate the knob to select desired menu point. Press the knob to enter the
next menu!
“Produce Object” to start
printing
Choose “Yes” to insert the
cartridge
The display shows
“Insert cartridge now!
Follow the loading instruction
and click “Done” after you
finished all steps of loading
3D Choco.
4.6 Loading 3D Choco and start printing production
Unpack your mycusini Choco refills
Take one Choco refill and
cut it exactly in the middle.
Put one half of this refill into the
cartridge (open side downwards).
The refill should not be longer than
the cartridge.
Open the cartridge holder by
rotation (see picture below).
OPEN
CLOSE
Place the cartridge with mycusini
3D Choco in the cartridge
holder.
If the refill or the clip comes out
the cartridge, the refill is too long.
Please shorten it at the open
edge.
Close the cartridge holder by
rotation (see picture below).
Preheating starts automatically
When preheating is finished you
may choose your object from the
SD card.
Choose your object by rotating
the rotary control knob and
confirm by pressing it.
Back
►
Produce Object
.
Clean
>>
Load Choco
>>
Turn off
>>
Change cartridge now?
►
Yes
>>
►
No
