original operating instructions mycusini
For questions please contact us at [email protected]
4.3 The main menu
Press the control knob to get to the main menu. In the main menu you will find
various options. For more information, take a look at the mycusini Club, where you
will find video tutorials for the menus.
Produce Object:
Select "Produce Object" to produce a 3D object.
Clean:
Select "Clean" to clean the stamp of your mycusini. A detailed explanation of
this menu can be found under point 5.3.1 Quick cleaning of the stamp.
Turn off:
Select "Turn off" to turn off your mycusini.
Maintenance:
Select “Maintenance” to use expert options. A detailed explanation of
this menu can be found under point 4.4 The Maintenance menu.
4.4 Installation
4.4.1 Installation of the mycusini
1. Put the mycusini on a stable underground
2. If the SD card isn´t already inserted, please insert SD card (see
picture on the right)
3. Plug in power supply
4. Place the flexible mat
4.4.2
Preparation of the flexible silicone
production mat
Remove the protective film before first use, clean with warm soapy water and dry
thoroughly prior to first use. Place the flexible production mat onto the production plate,
until you obtain a flat surface.
Do not cut on the flexible production mat. Do not use any sharp objects which
can perforate or cut up the production mat. Never use a flexible production
mat which has tears or cuts.
4.5 Preparation of the production
1. The display screen shows the main menu after starting 2. Press the control knob.
Theprinter is automatically moving to check all axis
3. Press the control knob again to access the main menu
Back
Produce Object
►
Clean
>>
.
Turn off
>>
Maintenance
>>
