10
3.
Connect conveyor power cord to a grounded 105/120 VAC, 50/60 Hz electrical source.
4.
Set up delivery device (i.e. printer) for desired media.
5.
The setup of the conveyor (which includes drop tray height, stop plate position, envelope knock down position, belt
speed, and fan combination) is in direct relation to type, size and speed of media being delivered to the conveyor.
Send a test piece of media through delivery device (i.e. printer) to adjust proper distance of envelope knockdown
guide away from exit end of delivery device.
Start (power on) conveyor. Send a few test pieces of media through delivery device. Set conveyor belt speed to
obtain desired gap between pieces of media. Fans can be used to control media movement once it drops onto the
conveyor belt. Set fan controls as desired.
Note:
At
very low conveyor transport speed settings the transport belt may stall easily, especially when the fans
and/or dryer are being used. Increase the transport speed setting to prevent this condition.
Power Toggle Switch
Speed Control
Fan Toggle Switches
Control Panel
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
