AC•THOR
®
/ AC•THOR
®
9s Operating instructions, version a0020806
10
Meter: shows the current data for the meter at the measuring point. A positive value shows drawing
from the grid, a negative value, feeding into the grid.
PV: If a corresponding measuring point has been set in the Web-Interface under Setup, the value of
the PV power is available here. See Measurement Settings.
Load: shows the nominal power of the load (at 230 V) which is currently being supplied by the
AC•THOR output unit. This value can be determined from an output of 500 W.
With
AC•THOR
9s, the load status (0 or 1) at the three outputs is displayed at this point.
If "none" or "0" is displayed even though a load is connected, the cause may be a thermostat that
has been switched off or a safety temperature limiter that has been triggered.
Temperature 1: Current data probe 1
Temperature 2: Current data probe 2
Temperature 3: Current data probe 3
Temperature 4: Current data probe 4
IP:
shows the current IP address of the AC•THOR.
Ctrl IP: shows the current IP address of the signal source. Shown in addition in the line below is the
designation of the signal source and the current measured value. A positive value shows drawing
from the grid, a negative value, feeding into the grid.
Status: Shows the unit's current status. See chapter "Status codes".
For AC
•
THOR 9s the number consists of two parts. On the left the status code of power unit
AC•
THOR 9s, on the right the status code of power unit AC
•
THOR.
Grid voltage: shows the current input voltage at th
e AC•THOR (
only with AC
•
THOR)
Grid power: shows the curren
t input power at the am AC•THOR (
only with AC
•
THOR)
Output voltage: shows the curren
t output voltage of the AC•THOR (
only with AC
•
THOR)
Power 1: Power at output Out-1 (only with AC
•
THOR 9s)
Power 2: Power at output Out-2 (only with AC
•
THOR 9s)
Power 3: Power at output Out-3 (only with AC
•
THOR 9s)
Frequency: shows the current grid frequency.
Temperature output unit:
shows the current temperature of the AC•THOR power electronics.
Fan: shows the current speed setting of the internal fan.
Serial number: shows the unit serial number.
MAC address: shows the MAC address of the unit.
Version: shows the current firmware version of the unit.
Version power stage: shows the current firmware vers
ion of the AC•THOR output unit.
For AC
•THOR 9s the
firmware version of the PS consists of two parts.
pXXX: Power
stage AC•
THOR
sXXX: Power
stage AC•
THOR 9s
Device number: shows the unit number set. This is also visible on the home screen.
Operating mode: shows the operating mode set (M1
–
Mx). This is also visible on the home screen.
Latest firmware: shows the latest firmware version, or "current" is displayed.
Update status: Ok, loading (number of files), or waiting for installation
Output unit update status: Ok, loading, or waiting for installation
Cloud Status: Regardless of whether the cloud mode is active or not, it is displayed whether the
cloud server my-PV.LIVE is reachable. If the info "99, Timeout" is displayed at this point, please
send the 16-digit serial number to [email protected].
