7
4.
Position the mixer valve onto the two water feed pipes and onto the wall bracket.
Tighten up the compression nuts to hold the mixer valve in place. Make sure the
mixer valve outlet is pointing down and the hot feed is onto the left side marked with a
red indicator (See Fig 13).
NOTE: It is possible to move the outlet to the top of the valve by reversing the plug and
threaded outlet.
5.
Replace the locking screws to hold the mixer valve on the wall plate (See Fig 14).
6.
A pipe must be fitted from the outlet of the mixer valve to the location of where you
wish to position the outlet. Depending on the option this pipe must have a ½” female
connection attached into which the outlet can be fitted.
NOTE: Once the mixer valve and outlet are fitted, prior to fitting the trim plate ensure all
connections are watertight. This can be done by reconnecting the water supplies and
checking the connections when running the shower and when the shower is off.
TRIM PLATE FITTING FOR Atmos Zinc/Zone
1.
The trim plate is fitted by pushing it onto the mixer valve until flush with the tiles
(See Fig 15 & 16).
NOTE: Before assembling the valve controls identify all the parts and check that red
markings on the thermostatic cartridge are inline.
ASSEMBLING FRONT OF VALVE FOR Atmos Zinc
1.
Fit the flow control knob onto the large spline, aligning arrow with the line on the
line on the main body with the lever pointing down (See Fig 17).
2.
Fit the stop ring onto the middle spline aligning the V notch with the arrow on the
flow control lever, then hold firmly in position and tighten the grub screw using
the allen key supplied (See Fig 18).
3.
Fit the temperature control knob with the arrows inline and the override button
on the right hand side. Hold firmly in position and tighten the grub screw with allen
key supplied. Then fit cap to hole on the temperature control knob (See Fig 19).
Wall
14
15
16
