MX Atmos Azure, Fitting Instructions Manual

Page: 9 / 16

9. FITTING THE VERTICAL RAIL AND HANDSET (CONT.)
7. Attach the top overhead rail to the vertical rail and
screw until hand tight. The ‘O’ ring provides a seal
so it does not need to be overtightened (Fig 6).
NOTE: Ensure the locking washer is on the rail and do
not tighten the locking nut between the two vertical
tubes until the rail has been completely fitted. If
desired the telescopic extension rail can be tightened
at the required height for use.
8. Screw the overhead assembly to the top of the
diverter valve making sure the washer is fitted.
It does not need to be overtightened as a rubber
washer is supplied (Fig 7).
9. Locate the overhead rod into the wall bracket,
check it is vertical with a spirit level. Using the
supplied allen key secure the overhead assembly to
the wall bracket by tightening the lock screw in the
top of the riser rail collar (Fig 8).
NOTE: There is a small amount of depth adjustment
within the collar. Adjust the depth of the bracket
before securing in place to the mounting plate.
10. Screw the large fixed showerhead to the overhead
assembly. Make sure the sealing washer is in
place and screw tight to seal the joint (Fig 9).
11. Connect one end of the shower hose to the
diverter on the mixer valve, making sure that the
sealing washer is in place. Screw the remaining
end of the shower hose to the showerhead then
locate the showerhead into the height adjuster
(Fig 10).
8
7
6
9
10