CAT880 - NLFREN - v1.0 - 19122016
EN
TOOLS
12
Important warning
Read all instructions before using this equipment.
1. Start up preparation
- Supply air line should be sized according to the table shown on page 16. All hoses should be rated at least 125
psi/8.61 bar and an isolation valve should be installed so that supply air can be turned off and then disconnected
from blast machine for servicing.
- Supply air should be dry and clean from oil and other contaminants (use air dryer, coalescent filter or moisture
separator as needed).
- Blast machine must be grounded to avoid shock.
- Electric extension cords should be three wire grounded, and rated for the amperage of the blaster. Check nameplate
for rated amps.
2. Operator’s responsibilities before starting
- Inspect fittings and hoses for damage and wear.
- Check the seal on all doors. Only operate the blast cabinet with all doors securely closed and dust collection system
running.
- Clean dust from dust collector and clean filter as needed.
3. Caution
- Watch for silicosis (from dust created when using silica sand as a blast media) or toxic dust hazard.
Do not use media containing free silica
.
- Unless otherwise specified, working pressure of blast machine and related components must not exceed 125
psi/8.61 bar.
- Keep blast nozzle controlled and aimed at the work.
4. Maintenance
- Keep your machine in good repair. Use original parts and do not substitute or modify supplied items.
5. To distributors, purchasers and end users
- The information provided, described and illustrated in this material is intended for experienced, knowledgeable
users of abrasive blasting equipment and supplies (products).
-The products described in this material may be combined as determined solely by the user in a variety of ways and
purposes. However no representations are made as to intended use, performance standards, engineering suitability,
safe practice or compliance with government regulations and laws that apply to these products, products of others, or
a combination of various products chosen by the user or others. It is the responsibility of the users of these products,
products of third parties, and a combination of various products, to exercise caution and familiarize themselves with
all applicable laws, government regulations and safety requirements.
- Nor are representations made or intended as to the useful life, maintenance cycles, efficiency or performance of the
referenced products of any combination of products.
- This material must not be used for estimating purposes. Production rates, labour performance or surface finishes are
the sole responsibility of the user based on the users expertise, experience and knowledge of industry variables.
- It is the responsibility of the user to insure that proper and comprehensive training of operators has been performed
and all environmental and safety precautions observed.
- Before using this product, read all instructions, literature, labels, specifications and warnings sent with and affixed
to the unit. If operation of the unit is unclear after reading this manual, contact your supervisor for instructions. It is
the responsibility of the employer to read the following instructions to users of this equipment, who are unable to
read. Periodic inspection at the work site should be made by supervisory personnel to insure the blast machine is
being properly used and maintained. A copy of this owner’s manual must be kept with the blast machine and readily
accessible to the blast machine operators at all times.
copyrighted
document
- all
rights
reserved
by
FBC