7
WT500 - NLFREN - v1.0 - 10012017
EN
TOOLS
3 Assembly
Unpack the table and check contents with list below. Should there be any damaged or missing parts, contact your supplier
immediately.
Content
• Lift table Assembly
• Lifting pedal
• Handle Assembly
Assembly
1.
The table cart is almost completely assembled when you open it. To complete the assembly find the diagram and parts List.
2. Place the lifting pedal (27) into the lifting pedal assembly (30) using bolt (29).
3. Install the handle (21) to the base assembly (17) using bolt (20).
4. Your assembly is complete! Use the rubber mat for the table top when needed.
4 Operating instructions
WARNING!
Ensure that you read, understand and apply the safety instructions and warnings before use.
Failure to heed these instructions may result in property damage and/or personal injury.
1. Before loading and while stationary, lock the wheel stop supports
2. Table is raised by activating the lifting pedal (27).
3. After raising the load, turn the locking bar (7) clockwise till reach the safety position. Before lowering, please turn the
locking bar (7) back.
WARNING!
Keep all personal clear of the toptable (1) and base assembly (17) when the table is being
lowered.
5 Maintenance
• When not in use, the table must be stored in the lowest position in a dry location to minimize ram and piston corrosion.
• Lubricate each friction point monthly with a good grease.
• Inspect all joints and bolts periodically. Remove from service if any cracking or if the frame is bent or deformed.
•
If you find that the lifting range per stroke is too small, please lift the table to 2/3 of the maximum height, then loosen the
oil plug (P04) and then tighten it.
• Check the hydraulic oil level. If it is not adequate, remove the oil plug (P04) on the hydraulic pump and add hydraulic oil as
necessary. Do not use brake fluid or any other improper fluid. Only a good quality hydraulic jack oil can be used.
copyrighted
document
- all
rights
reserved
by
FBC
