MV Agusta F4 1000 S, Workshop Manual

Page: 278 / 428

1
2
Suspension and wheels
F
- 74 -
For reassembly, insert the pinion to end stroke.
Take a new washer, assemble it with the nut and tight-
en to the prescribed torque pressure utilising Loctite
thread-locking fluid.
Hammer the new washer down onto the two opposite
faces of the hexagon.
Torque pressure: 140 N·m
Recommended thread-locking fluid: Loctite 243
Remove the chain as described on pages 51-53.
Reassemble the pinion wheel cover after having clea-
ned the support base.
Screw in the four screws lightly and proceed with the
tightening, screwing down respectively on the three
screws M8 (
1 ) and on the screw M6 ( 2 ).
Torque pressure (M8 Screws): 25 N•m
Torque pressure (M6 Screws): 8 N•m
140 N•m
25 N•m
8 N•m
Using the specially designed spanner, remove nut ( 1 )
and washer ( 2 ).
Remove the pinion and replace it with a new pinion.