© MuxLab Inc.
Active Component Video Balun Kit Installation Guide
Page 11
To install the receiver, please follow the steps below:
6.
Connect the Active Component Video Balun
receiver to the display equipment with the
appropriate component video & audio jumper cables.
7.
(Optional) Connect an infrared receiver to the 2
position terminal block.
8.
Connect the UTP cable to the Video IN/UTP
connector of the receiver.
9.
Connect the second 12 VDC power supply to the
receiver.
10.
Plug the power supply into an AC power outlet. If
power is present, the green power LED will be ON.
11.
To adjust the picture quality, rotate the brightness
rotary switch and/or sharpness potentiometer on the
rear panel of the Active Component Video Balun
receiver. The factory default position for the
brightness (“Bright”) is “None,” and the factory
default position for the sharpness (“Sharp”) is zero
(rotated completely counterclockwise).
Figure 3: Brightness and Sharpness Adjustment
