KVM DVI over IP PoE Extender - 500771
© MuxLab Inc. 2016
94-000846-A / SE-000846-A
Page 10
4 KVM Transmitter/Receiver Settings
The following section describes how to set and configure the KVM Transmitter and Receiver via their
web interface. To access either the KVM Transmitter or Receiver web interface, begin by entering the
KVM Transmitter/Receiver IP address into a computer web browser and press enter. Make sure the
computer is connected to the same subnet as the KVM Transmitter/Receiver, and that it has an IP
address that is within the same subnet range. Login, if required, with the appropriate password (the
factory default password is “admin”).
4.1 Firmware Version Information
To access the Firmware version information, press on the “System” tab, and then on the “Version
Information” sub tab. This will bring up the firmware version information for the given KVM
Transmitter/Receiver. An example KVM Transmitter version information screen is shown below.
4.2 Upgrading Firmware
To upgrade the firmware, begin by verifying your current KVM Transmitter and Receiver firmware
versions. To do this, follow the steps in the “Firmware Version Information” section. Then search for the
latest version of the KVM Transmitter and Receiver firmware on the MuxLab website in the “Support”
page section. If a newer version exists, then proceed to download it.
To upgrade the KVM Transmitter/Receiver, from the device web interface click on the “System” tab and
then on the “Upgrade Firmware” sub tab, see the example below. Press the “Browse” button to browse
for the file previously downloaded, and once selected, press the “Upload” button to upgrade the KVM
Transmitter/Receiver.
