VJ-1627MH Daily Maintenance Sheet
CS3013-01
-1-
Daily maintenance
1.
Put the printer into maintenance state
1
2
Daily Maint.:
Start
Put the printer into Sleep Mode.
When [Daily Maint.: Start] appears on the operation
panel, press the [Enter] key.
Operation Manual
”Sleep Mode”
Daily Maint.:
End
When [Daily Maint.: End] appears on the operation
panel, open maintenance cover on the right side of
the printer and remove it.
You can start the daily maintenance with following
steps.
The carriage will move to the left side of the printer.
Make sure to complete this maintenance within
5 minutes while the printer is in maintenance state.
If it takes longer, the stick can dry causing damage to
the print head.
Important!
Maintenance Precautions
When performing daily maintenance, check the points below:
Do not touch the cleaning wiper and the capping unit with your hands.
If oil from your hands gets on those parts, this cleaning may not be performed properly.
Do not touch the print head surface with fingers or a cleaning stick.
It can cause damage to the print head.
Always use a cleaning stick dampened with the dedicated maintenance cleaner in the plastic cup.
DO NOT use non-dedicated maintenance cleaner. It may cause nozzle clogging.
DO NOT touch the tip of the cleaning sticks with your finger.
If finger oil gets on the stick, it will damage the print head.
When to perform maintenance:
At the end of the working day
(Be sure to perform the following maintenance)
Preparation:
Required Items:
(a) Dedicated maintenance cleaner
(b) Plastic cup for cleaning stick
(c) Cleaning stick
(d) Paper towel or Polyester knit wiper
(e) Plastic cup for dropper
(f ) Dropper
(g) Plastic gloves
(h) Plastic zipper bag
(i) Cleaning stick
Use a paper towel supplied with the printer or optional
Polyester knit wiper. DO NOT use a tissue.
Lints or flakes on tissue may cause damage to the print
head.
DO NOT use non-dedicated maintenance cleaner.
Wear the plastic gloves.
Important!
Plastic cup for dropper
When you drop maintenance cleaner onto printer parts using the dropper, do NOT
use the maintenance cleaner in the plastic cup that the cleaning stick is submerged.
In this maintenance procedure, you will moisten some printer parts with mainte-
nance cleaner using the dropper. If you cannot suck up maintenance cleaner
directly from the maintenance cleaner bottle using the dropper, use one of the
plastic cup to pour the cleaner.
If the maintenance cleaner still remains in the plastic cup, put a plastic bag or wrap
over the cup to keep out dust.
b
a
e
f
d
g
c
i
h