MUTOH Viper Extreme, User Manual

Page: 63 / 148

User’s Guide Viper Extreme
CHAPTER 5: Printer menu
63 AP-75330 – Rev. 1.0 – 14/01/09
5.2.6 Start printing while waiting for heaters
A new option called "PrintStart" is available in the Heater status menu. Normally you wait until the heaters
are warmed up, when you choose this option, printing will start immediately. However, the heaters will
continue to warm up in order to reach the requested temperature.
Notes
For the best print output, wait until the heaters are warmed up before you start printing
5.2.7 Pause function while printing.
Notes
It is not recommended to open the cover while printing.
When pausing the print job, heaters switch off after 15 minutes. When resuming the print job after 15
minutes, you must reset the heaters to their correct setting.
While printing you can pause and resume the print job by pressing the [F4] key
When pressing “pause” the printer will finish the cu rrent band. The carriage will stay still at the end of the
band for about 15s. After 15s the carriage will move to the carriage station and the heads will be capped in. if
you open the cover within these 15s you can move the carriage. Please note that when closing the cover
again after moving the carriage, the printer will move the carriage SLOWLY back to the correct print position.
While this move is in progress, the “Cover Open” message stays on the display.
While pausing a print job, you can unlock or lock the heads by pressing ENTER. This to perform manual
maintenance. Press Resume to resume the print job. You can also change the Dist. Adj. or start a cleaning.